ROCHESTER QUADRAJET CARBURETORS
Available in both Buick-Olds-Pontiac and Chevy Styles
in BOTH 1/24 and 1/25 Scales!

FMR-042 and FMR-043
For your classic GM Musclecar Scale Model!

100% Original Pieces designed in 3D! Not a recast of any existing kit part!
No kit manufacturer has been able to offer parts with this kind of detail in a mass-marketed kit!


click for larger view:      Prototype perched on a Monogram Buick 455

            
In real life, there are dozens of Quadrajet models, all just a little different from each other.  These models are based on the 1969 4MV version of the Quadrajet.
The Buick-Olds-Pontiac (BOP) version has the front fuel inlet going straight into the body.  The Chevy (CHV) version has the fuel inlet at a right angle to the carb body, pointing at the passenger side.

With parts this
size, there is not a whole lot of difference in 1/24 and 1/25.  But trust me, the 1/25 version is 4% smaller than the 1/24 version!


What You Get
Each box contains two carburetor castings pressure-cast in light gray urethane plastic.
I highly recommend using a razor saw to separate the carb piece from its casting block!

FMR-042-BOP Resin Quadrajet Carbs for Buick-Olds-Pontiac (Pair), 1/24   $3
FMR-042-CHV Resin Quadrajet Carbs for Chevy (Pair), 1/24                         $3

FMR-043-BOP Resin Quadrajet Carbs for Buick-Olds-Pontiac (Pair), 1/25   $3
FMR-043-CHV Resin Quadrajet Carbs for Chevy (Pair), 1/25                         $3

Shipping is not included in these prices

Please see the main page for ordering information
 

Back to Index


This page was last updated 01/24/2016 12:46 PM -0600

All Content 2015 Fireball Modelworks. All rights reserved
All trademarked names are used for descriptive purposes only